• [ CXCO4335 ]

样品申请

目录

1.产品概述       2.产品特点     YNV嘉泰姆

3.应用范围       4.技术规格书下载（PDF文档）YNV嘉泰姆

5.产品封装       6.电路原理图  YNV嘉泰姆

7.相关产品YNV嘉泰姆

   产品概述 返回TOPYNV嘉泰姆

The CXCO4335 is a qual bidirectional I2 C and SMBUS voltage-level translator with an output enable (OE) input, and is operational from 1.2V to 3.3V VCCA and 2.5V to 5.5V VCCB. It allows bidirectional voltage translations between 1.2V and 5V, without use of directional pin. The low ON-state resistance (rON) of the switch ensures the connections to be with minimal propagation delay. When OE is high, the translator switch is ON, and the AN I/O are connected to the BN I/O, respectively, allowing bidirectional data flow between ports. When OE is low, the translator switch is off, and a high-impedance exists between ports. Pull-up resistors are included on input and output lines internally to provide the logic high levels on the translator’s bus. The size of the pull-up resistors are 10kΩ, and is allowed to use lower pull-up resistor value to minimal 1kΩ by adding external resistor. All channels have the same electrical characteristics, and there is minimal deviation from one output to another in voltage or propagation delay. This is a benefit over discrete translation solutions, since the fabrication of the switch is symmetrical.

   产品特点 返回TOPYNV嘉泰姆

„ 4-Bit Bidirectional Translator for Open Drain and Push-Pull Bus Applications YNV嘉泰姆

„ I 2 C and SMBus Compatible YNV嘉泰姆

„ Less than 1.5ns Maximum Propagation Delay to Accommodate Standard-Mode and Fast-Model I 2 C Devices and Multiple Masters YNV嘉泰姆

„ Allows Voltage-Level Translator Between YNV嘉泰姆

Š 1.8V VCCA and 2.5V, 3.3V, 5V VCCB YNV嘉泰姆

Š 2.5V VCCA and 3.3V, 5V VCCB YNV嘉泰姆

Š 3.3V VCCA and 5V VCCB YNV嘉泰姆

Š VCCA ≦ VCCB YNV嘉泰姆

„ Provides Bidirectional Voltage Translation without Direction Pin YNV嘉泰姆

„ Max Data Rates YNV嘉泰姆

Š 24Mbps for Push Pull YNV嘉泰姆

Š Over 1.3Mbps for Open Drain YNV嘉泰姆

„ Low 3.5Ω ON-State Connection Between Input and Output Ports Provides Less Signal Distortion YNV嘉泰姆

„ Open-Drain I2 C I/O Ports YNV嘉泰姆

„ 5V Tolerant I2 C I/O Ports to Support Mixed Mode Signal Operation „ High Impedance AN and BN Pins for OE=Low YNV嘉泰姆

„ Lock-up-Free Operation for Isolation When OE=Low YNV嘉泰姆

„ IEC 61000-4-2 Level 4 (±8kV Contact Discharge and ±15kV Air-gap Discharge) ESD Protection for pins B1, B2, B3, B4, OE and VCCB. 2kV HBM IEC61340-3-1 Protection for All Other Pins.YNV嘉泰姆

   应用范围 返回TOPYNV嘉泰姆

   aYNV嘉泰姆

   技术规格书（产品PDF) 返回TOP YNV嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！YNV嘉泰姆

 YNV嘉泰姆

产品封装图 返回TOPYNV嘉泰姆

YNV嘉泰姆

电路原理图 返回TOPYNV嘉泰姆

aYNV嘉泰姆

相关芯片选择指南 返回TOP                 更多同类产品。。。。。。

◀ 上一篇:CXCO4334在1.2V和5V之间进行双向电压转换启用EN输入的双向I2C和SMBUS电压电平转换器用于混合模式I2C应用中SDA和SCL线路的2位双向转换器输入和输出端口之间的低3.5Ω接通状态连接提供的信号失真

返回顶部

下一篇▶:CXCO4336双向I2C和SMBUS电压电平转换器有启用EN输入工作电压范围为1.2V至3.3V VREF1和2.5V至5.5V VREF2输入和输出端口之间的低3.5Ω接通状态连接提供较少的信号失真 开漏I2C I/O端口支持混合模式信号操作的5V耐受I2C I/O端口

共有条评论 用户名: 密码: 验证码: 匿名发表