CXCO4332此4位非垂直转换器使用两个单独的可配置电源轨。A端口设计用于跟踪VCCA。VCCA接受1.2V到3.6V的任何电源电压。B端口设计用于跟踪VCCB。VCCB接受1.65V到5.5V的任何电源电压。这允许在1.2V、1.5V、1.8V、2.5V、3.3V和5V电压节点之间进行通用低压双向转换。VCCA不应超过VCCB。当使能输出（EO）输入低时，所有输出都处于高阻抗状态。为了确保在通电或断电期间的高阻抗状态，EO应通过下拉电阻器连接到GND；电阻器的最小值由驱动器的电流源能力决定。CXCO4332的设计使得EO输入电路由VCCA提供。此设备完全指定用于使用“关闭”的部分关机应用程序。断开电路会禁用输出，防止设备断电时损坏的电流回流。
·端口1.2V至3.6V，B端口1.65V至5.5V（VCCA≤VCCB）
·VCC隔离特性如果任一VCC输入处于GND，则所有输出均处于高阻抗状态
·参考VCCA的EO输入电路
低功耗，最大5μA ICC
·无需电源顺序，VCCA或VCCB可先倾斜
“关闭”支持部分断电模式操作
·锁存性能超过100毫安/JESD 78，II级
·ESD保护超过JESD 22–A端口2500V人体模型（A114-B）1500V充电装置模型（C101）–B端口±15kV人体模型（A114-B）1500V充电装置模型（C101）
-
[ CXCO4332 ]
目录
7.相关产品
产品概述 返回TOP
This 4-bit noninverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2V to 3.6V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65V to 5.5V. This allows for universal low-voltage bidirectional translation between any of the 1.2V, 1.5V, 1.8V, 2.5V, 3.3V, and 5V voltage nodes. VCCA should not exceed VCCB. When the enable-output (EO) input is low, all outputs are placed in the high-impedance state. To ensure the high-impedance state during power up or power down, EO should be tied to GND through a pulldown resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver. The CXCO4332 is designed so that the EO input circuit is supplied by VCCA. This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down.
产品特点 返回TOP
„ 1.2V to 3.6V on A port and 1.65V to 5.5V on B port (VCCA ≤ VCCB)
„ VCC Isolation Feature-If Either VCC Input Is at GND, All Outputs Are in the High-Impedance State
„ EO Input Circuit Referenced to VCCA
„ Low Power Consumption, 5μA Max ICC
„ No Power-Supply Sequencing Required-Either VCCA or VCCB Can be Ramped First
„ Ioff Supports Partial-Power-Down Mode Operation
„ Latch-Up Performance Exceeds 100mA Per JESD 78, Class II
„ ESD Protection Exceeds JESD 22 – A Port 2500V Human-Body Model (A114-B) 1500V Charged-Device Model (C101) – B Port ±15kV Human-Body Model (A114-B) 1500V Charged-Device Model (C101)
„ SC-70-6 (SOT-363), SOT-23-6, SOT-23-8, AQFN1.7X2.0-12 and AQFN1.5X1.5-8 Package
应用范围 返回TOP
a
技术规格书（产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
产品封装图 返回TOP
电路原理图 返回TOP
相关芯片选择指南 返回TOP 更多同类产品。。。。。。
|
Level Shifter |
|||||||||
|
Part NO. |
VDD(V min. |
VDD(V max. |
CH |
IOUT (mA) |
VLOW (V) |
VHIGH (V) |
S/R (ns) |
Note |
Package |
|
6 |
16 |
5 |
50 |
0 |
18 |
25 |
2 Vcom buffers |
TQFN5X5-32 |
|
|
-- |
-- |
8 |
500 |
-35 |
35 |
12 |
VGH1-VGL 6-CH,VGH2-VGL 2-CH |
TSSOP20/TQFN4X4-20 |
|
|
2.6 |
5.5 |
10 |
500 |
-30 |
40 |
700 |
Gate Power |
TQFN5X5-40 |
|
|
1.2 |
5.5 |
2001-2-4 |
-- |
1.2 |
5 |
17 |
1-2-4-Bit Bidirectional Level Shift, Push-Pull Input/Ouput |
SC70-6/SOT23-6/ AQFN1.7X2.0-12 |
|
|
2.6 |
5.5 |
9 |
-- |
-30 |
40 |
-- |
N/A |
TQFN5X5-40 |
|
|
1.2 |
5 |
2 |
-- |
1.2 |
5 |
-- |
1-Bit, 2-Bit Bidirectional I2C Bus&Voltage-Level Shift, Open drain Input/Ouput |
SC70-6/TDFN3X2-8/ADF N3X2-8/AQFN1.5X1.5-8 |
|
|
1.65 |
5 |
4 |
-- |
1.8 |
5 |
240 |
4-Bit Bidirectional Level-Shift,Open Drain Input/Ouput |
WLCSP3X4-12 |
|
|
1.2 |
5 |
1 |
-- |
1.2 |
5 |
-- |
1-Bit,2-Bit Bidirectional I2C Bus &Voltage-Level Shift,Open drain Input/Ouput |
SC70-6/TDFN3X2-8/ADF N3X2-8/AQFN1.5X1.5-8 |
|
| 头条信息 |
|---|
