• [ CXLE8169 ]

样品申请

目录

1.产品概述       2.产品特点     awd嘉泰姆

3.应用范围       4.技术规格书下载（PDF文档）awd嘉泰姆

5.产品封装       6.电路原理图  awd嘉泰姆

7.相关产品awd嘉泰姆

   产品概述 返回TOPawd嘉泰姆

      CXLE8169A是一款专为白光LED设计的升压型恒流驱动器. 通过内置40V功率管，使得CXLE8169A能驱动单串10LEDs串连负载，从而保证所有LED电流相同。CXLE8169A工作在1.2MHz震荡频率和1.3A电流极限，也能用于通用型的高亮度LED照明。如典型应用电路所示，CXLE8169A回馈电压为200/mV，通过回馈电阻可以设置LED最大输出电流。在工作过程中,EN引脚可以以两种调光方式对CXLE8169A的工作电流进行控制。一是PWM调光方式，通过外加在EN端8KHz 或更高频率的PWM调光信号，PWM调光信号的占空比决定反馈电压的大小。二是数字调光方式，通过在EN端集成一个单线接口，该单线接口可以以32阶调节反馈电压的大小。不管工作在PWM模式还是数字调光模式，CXLE8169A都不会在输出电容上产生音频噪声。其内置38V过压保护功能为LED提供开路保护。CXLE8169A采用2mm×2mm TDFN封装，可以节省面积。The CXLE8169A is a constant current step-up converter specifically designed to drive white LEDs. With a 40V rated integrated switch FET, the step-up converter supports up to 10 white LEDs in series connection, so the LED currents are identical for uniform brightness. The boost converter runs at 1.2MHz fixed switching frequency with 1.3A switch current limit, and allows for the use of a high brightness LED in general lighting. The maximum white LED current is set with the external sensor resistor RFB, and the feedback voltage is regulated to 200mV, as shown in the typical application. During the operation, the LED current can be controlled through the EN pin in two modes. With a 8KHz or higher frequency PWM dimming signal on EN pin, CXLE8169A operates in PWM dimming mode, which the duty cycle determines the feedback reference voltage. CXLE8169A can operate in digital dimming mode also, which a Single Wire interface on the EN pin is integrated to adjust the FB voltage in 32 steps. In either digital or PWM mode, the CXLE8169A does not generate audible noises on the output capacitor. For the over voltage protection, the CXLE8169A provides 38V OVP to prevent damage from LED open. The CXLE8169A is available in a space-saving 2mm×2mm TDFN package.

   产品特点 返回TOPawd嘉泰姆

 awd嘉泰姆

‧2.7V～5.5V输入电压awd嘉泰姆

‧38V过压保护awd嘉泰姆

‧集成40VNMOS功率管awd嘉泰姆

‧内置软启动awd嘉泰姆

‧单线协议提供32阶LED电流调节awd嘉泰姆

‧PWM调光频率范围：8KHz~300KHzawd嘉泰姆

‧过温保护awd嘉泰姆

‧输入欠压锁定awd嘉泰姆

‧2mm×2mm TDFN-6封装awd嘉泰姆

‧符合RoHS规范及Pb-Freeawd嘉泰姆

2.7V to 5.5 V Input Voltage Rangeawd嘉泰姆

38V Output Over Voltage Protectionawd嘉泰姆

Integrated 40V N-MOSFETawd嘉泰姆

Internal Soft-Startawd嘉泰姆

Single-Wire Serial Pulse Interface to Set LEDawd嘉泰姆

Current with 32-Step Scaleawd嘉泰姆

External PWM Dimming with 8kHz to 300kHzawd嘉泰姆

Frequency Rangeawd嘉泰姆

Over Thermal Protectionawd嘉泰姆

VIN Under Voltage Lockoutawd嘉泰姆

Available in 2mm×2mm TDFN-6 packageawd嘉泰姆

RoHS Compliant and 100% Lead (Pb)-Freeawd嘉泰姆

Halogen-Freeawd嘉泰姆

   应用范围 返回TOPawd嘉泰姆

 awd嘉泰姆

‧移动电话awd嘉泰姆

‧GPS 导航系统awd嘉泰姆

‧便携媒体播放器awd嘉泰姆

‧手持设备、数码相机awd嘉泰姆

‧便携游戏机awd嘉泰姆

Mobile Phonesawd嘉泰姆

GPS Navigation Systemsawd嘉泰姆

Portable Media Playersawd嘉泰姆

Handheld Devices, Digital Cameraawd嘉泰姆

Portable Game Machinesawd嘉泰姆

   技术规格书（产品PDF) 返回TOP awd嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！awd嘉泰姆

 awd嘉泰姆

产品封装图 返回TOPawd嘉泰姆

aawd嘉泰姆

电路原理图 返回TOPawd嘉泰姆

 awd嘉泰姆

 awd嘉泰姆

相关芯片选择指南 返回TOP                更多同类产品......

 awd嘉泰姆

◀ 上一篇:CXLE8161输入电压从2.5V到6V固定1MHz开关频率电流模式和固定频率升压转换器内部软启动电路消除启动过程中的浪涌电流欠压锁定过温保护和电流限制电路

返回顶部

下一篇▶:集成PWM单线调光WLED升压恒流驱动单串10LEDs串连负载保证LED电流相同1MHz震荡频率和1.3A电流极限CXLE8170单线调光在EN端加入符合协议的脉冲信号获得32阶LED电流信号

共有条评论 用户名: 密码: 验证码: 匿名发表