目录eIa嘉泰姆

1.产品概述                       2.产品特点eIa嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 eIa嘉泰姆
5.产品封装图                     6.电路原理图                   eIa嘉泰姆
7.功能概述                        8.相关产品eIa嘉泰姆

 eIa嘉泰姆

一,产品概述(General Description)         eIa嘉泰姆
   CXSU63039 is a high efficiency synchronous boost regulator that convertseIa嘉泰姆

down to 2.5V input and up to 5.5V output voltage. It adopts NMOS for theeIa嘉泰姆

main switch and PMOS for the synchronous switch. It can disconnect the eIa嘉泰姆

output from input during the shutdown mode..eIa嘉泰姆

  It integrates 5A power MOSFET and can output 5V 2.5A with Li-Battery input.eIa嘉泰姆
二.产品特点(Features)eIa嘉泰姆
1.)2.5V Minimum input voltageeIa嘉泰姆
2.)Adjustable output voltage from 3V to 5.5VeIa嘉泰姆
3.)6A peak current limiteIa嘉泰姆
4.)Input under voltage lockouteIa嘉泰姆
5.)600Khz fixed Switching FrequencyeIa嘉泰姆
6.)Load disconnect during shutdowneIa嘉泰姆
7.)Integrated soft-starteIa嘉泰姆
8.)Output over voltage protectioneIa嘉泰姆
30moJTM Power MOSFETeIa嘉泰姆
Thermal ShutdowneIa嘉泰姆
QFN4x4-16 PackageeIa嘉泰姆
三,应用范围 (Applications)eIa嘉泰姆
1.) Handheld DeviceseIa嘉泰姆
2.)Power BankeIa嘉泰姆
3.)All Single Cell Li or Dual Cell Battery Operated ProductseIa嘉泰姆
四,产品封装图 (Package)eIa嘉泰姆
eIa嘉泰姆
eIa嘉泰姆

五,电路原理图eIa嘉泰姆
eIa嘉泰姆
eIa嘉泰姆
eIa嘉泰姆
六.产品PDF文档eIa嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！eIa嘉泰姆

 eIa嘉泰姆

七,功能概述eIa嘉泰姆

SYNCHRONOUS RECTIFIEReIa嘉泰姆
The device integrates an N-channel and a P-channel MOSFET transistor to realize aeIa嘉泰姆
synchronous rectifier. Because the commonly used discrete Schottky rectifier is replaced witheIa嘉泰姆
a low RDS(ON) PMOS switch, the power conversion efficiency reaches 96%. To avoideIa嘉泰姆
ground shift due to the high currents in the NMOS switch, two separate ground pins are used.eIa嘉泰姆
The reference for all control functions is the GND pin. The source of the NMOS switch iseIa嘉泰姆
connected to PGND. Both grounds must be connected on the PCB at only one point close toeIa嘉泰姆
the GND pin. A special circuit is applied to disconnect the load from the input duringeIa嘉泰姆
shutdown of the converter. In conventional synchronous rectifier circuits, the backgate diodeeIa嘉泰姆
of the high-side PMOS is forward biased in shutdown and allows current flowing from theeIa嘉泰姆
battery to the output. This device however uses a special circuit which takes the cathode ofeIa嘉泰姆
the backgate diode of the high-side PMOS and disconnects it from the source when theeIa嘉泰姆
regulator is not enabled (EN = low).eIa嘉泰姆
The benefit of this feature for the system design engineer is that the battery is not depletedeIa嘉泰姆
during shutdown of the converter. No additional components have to be added to the designeIa嘉泰姆
to make sure that the battery is disconnected from the output of the converter.eIa嘉泰姆
八,相关产品           更多同类产品........    eIa嘉泰姆

eIa嘉泰姆

共有条评论 用户名: 密码: 验证码: 匿名发表