|
CXHA3182 The 2-wire serial interface accepts standard System Management Bus (SMBus) Write Byte, Read Byte, Send Byte, and Receive Byte commands to program the alarm thresholds and to read temperature | |||||||||||||||||||||||||||||||||||||||||||||||||||
|
目录产品概述 返回TOP General Description The CXHA3182 is a precise digital thermometer that reports the temperature of both a remote sensor and its own package. The remote sensor is a diode-connected transistor typically a low-cost, easily mounted 2N3904 NPN type that replace conventional thermistors or thermocouples. Remote accuracy is ±1°C with no calibration needed. It also has a build-in noise filtering function in remote sensor measuring the diode temperature. The remote channel can also measure the die temperature of other ICs, such as microprocessors, that contain an on-chip, diode-connected transistor. The 2-wire serial interface accepts standard System Management Bus (SMBus) Write Byte, Read Byte, Send Byte, and Receive Byte commands to program the alarm thresholds and to read temperature data. The data format is 11bits plus sign, with each bit corresponding to 0.125°C, in two’s-complement format. Measurements can be done automatically and autonomously, with the conversion rate programmed by the user or programmed to operate in a single-shot mode. The adjustable rate allows the user to control the supply current drain. The CXHA3182 and CXHA3182-1 have the same functions but different SMBus slave addresses. This allows for one of each to be on the bus at the same time. The CXHA3182 is available in a small, 8-pin SOP, MSOP and TDFN surface-mount package.产品特点 返回TOP „ Two Channels: Measures Both Remote and Local Temperatures „ No Calibration Required „ Built-in Noise-Buster for Remote Sensor „ SMBus 2-Wire Serial Interface „ Programmable Under/Overtemperature Alarms „ Supports SMBus Alert Response „ Accuracy: ±1°C (+60°C to +100°C, remote) ±3°C (+60°C to + 100°C, local) „ 320μA (typ) Average Supply Current During Conversion „ +3V to +5.5V Supply Range „ Small 8-Lead SOP , MSOP and TDFN Package „ Remote Temperature Measurment up to 160°C by using offset shifting method (see “Measure Remote Temperature Higher Than 127°C” section) „ SMBus Inputs with Built-in MOS Switch to Prevent Reverse Current from Bus to IC VCC 应用范围 返回TOP Desktop and Notebook Central Office Computers Telecom Equipment Smart Battery Packs Test and Measurement LAN Servers Multi-Chip Modules Industrial Controllers 技术规格书（产品PDF) 返回TOP 需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
| |||||||||||||||||||||||||||||||||||||||||||||||||||
|
Temperature Transducer |
|||||||||
|
Part NO. |
VCC(V) min. |
VCC(V) max. |
Sensor Gain |
VOUT (V) |
Sensor Range(°C) |
Accuracy (°C) |
Isupply (μA) |
Note |
Package |
|
2 |
5.5 |
-11.6 |
2.5~0.3 |
-55~130 |
±1 |
18 |
Negative temperature coefficient output |
TO126F/SC70-5(SOT353) |
|
|
Digital Interface Temperature Sensor |
|||||||||
|
Part NO. |
VCC(V) min. |
VCC(V) max. |
Remote |
Local |
Interface |
Slave Address |
Accuracy (°C) |
Note |
|
