产品概述 返回TOPfeH嘉泰姆

      CXMD32105 can be operated in serial control mode or partial exterior control mode. When operating in partial exterior control mode, the mode of each CH is fixed by initial serial control setting. When operating in serial control mode, the mode of each driver can be setting by serial control.CXMD32105 is a 5+1-channel H-Bridge motor drivers IC for the digital camera and so on. It has four full-swing/constant voltage drivers and two full-swing/constant current drivers.

   产品特点 返回TOPfeH嘉泰姆

„ Built-in 4 full-swing/constant voltage drivers switched by serial control with brake function feH嘉泰姆

„ Built-in 2 constant current drivers for shutter or IRIS feH嘉泰姆

„ Low on-resistance (1.2Ω, sum of on-resistance of up side and bottom side) feH嘉泰姆

„ Output current：IOUT<=0.8A(max.) for each channel feH嘉泰姆

„ Built-in thermal shutdown (TSD, 150°C) feH嘉泰姆

„ Built-in CC mode weak excitation feH嘉泰姆

„ CH1/2 corresponds to STM control of 2-2 phase or 1-2 phase feH嘉泰姆

„ Built-in exclusive control mode: CH13/23 Æ the combination control mode of 6CH is set feH嘉泰姆

„ All power supply systems (VCC, VM12, VM3, VM45) can be set up with an independent power supply feH嘉泰姆

„ Power save mode corresponds by serial control setup „ PI (photo interrupter drive) 3 channel built-in. feH嘉泰姆

„ Small 32TQFN (4×4mm) is adoptedfeH嘉泰姆

   应用范围 返回TOPfeH嘉泰姆

Stepping motor driver/ DC motor driver for DSCfeH嘉泰姆

   技术规格书（产品PDF) 返回TOP feH嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！feH嘉泰姆