产品概述 返回TOPABy嘉泰姆

      CXMD3290/CXMD3290B is a 5+1-channel H-Bridge motor drivers IC for the digital camera and so on. It has one micro-stepping driver, two full-swing/constant voltage drivers and one full-swing/constant current drivers. CXMD3290 /CXMD3290B can be operated in serial control mode or partial exterior control mode. When operating in partial exterior control mode, the mode of each CH is fixed by initial serial control setting. When operating in serial control mode, the mode of each driver can be setting by serial control.

   产品特点 返回TOPABy嘉泰姆

„ Build-in one micro-steps drive mode is possible from 2-2 phase stepper drive to maximum 256 resolution micro-steps. ABy嘉泰姆

„ Built in 2 full-swing/constant voltage drivers switched by serial control with brake function ABy嘉泰姆

„ Built in 1 constant current drivers for shutter or IRIS ABy嘉泰姆

„ Low on-resistance (1.2Ω, sum of on-resistance of upside and bottom side) „ Output current：IOUT<=0.8A(max.) for each channel ABy嘉泰姆

„ Build-in thermal shutdown (TSD, 150°C) ABy嘉泰姆

„ All power supply systems (VCC, VM12, VM3, VM45) can be set up with an independent power supply ABy嘉泰姆

„ Power save mode corresponds by serial control setup ABy嘉泰姆

„ PI (photo interrupter drive) 3 channel built-in. ABy嘉泰姆

„ Small 28TQFN (4×4mm) is adopted ABy嘉泰姆

„ Build-in POR (power on reset).ABy嘉泰姆

   应用范围 返回TOPABy嘉泰姆

„ Stepping motor driver/ DC motor driver motor driver for DSCABy嘉泰姆

   技术规格书（产品PDF) 返回TOP ABy嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！ABy嘉泰姆