目录2PJ嘉泰姆

1.产品概述       2.产品特点     3.应用范围      4.技术规格书下载（产品PDF文档） 2PJ嘉泰姆
5.产品封装图   6.电路原理图  7.功能概述      8.相关产品2PJ嘉泰姆

 2PJ嘉泰姆

一,产品概述(General Description)      2PJ嘉泰姆
2PJ嘉泰姆
     The CXSU63034 is a highly efficient fix frequencysynchronous step-up2PJ嘉泰姆
DC/DC converter. Output voltage of the device is adjustable. Power2PJ嘉泰姆
dissipation during operation is only 40μA typical and drops to less than2PJ嘉泰姆
1μA in shutdown. The 0.85V to 5V input voltage range makes the CXSU630342PJ嘉泰姆
ideally suitable for single cell Li-ion battery, single or dual AA battery voltage2PJ嘉泰姆
step-up applications. Automatic PFM Mode operation increases efficiency at2PJ嘉泰姆
light loads, further extend battery life. Switching frequency is internally set at 1.2MHz, design for use of small value surface mount inductor, input and2PJ嘉泰姆
output capacitors. The internal synchronous switchesenhance efficiency.2PJ嘉泰姆
Anti-ringing control circuitry reduces EMI by damping the inductance effect2PJ嘉泰姆
in DCM mode. The CXSU63034 is available in SOT23-6 package.2PJ嘉泰姆
二.产品特点(Features)2PJ嘉泰姆
2PJ嘉泰姆
Input Voltage Operating Range: 0.85V to 5V2PJ嘉泰姆
Voltage Output Range: 2.5V to 5.5V2PJ嘉泰姆
Efficiency Up to 94%2PJ嘉泰姆
3.3V/100mA Output at 1.0V Input2PJ嘉泰姆
5V/700mA Output at 3.6V Input2PJ嘉泰姆
Low Start-up Voltage: 0.85V Typical2PJ嘉泰姆
1.2MHz Constant Frequency Operation2PJ嘉泰姆
Internal Synchronous Rectifier2PJ嘉泰姆
EMI Reduction Anti-Ring Control Circuitry2PJ嘉泰姆
Low Shutdown Current: < 1.0uA2PJ嘉泰姆
Over Current Protection2PJ嘉泰姆
Over Temperature Protection2PJ嘉泰姆
Light Load PFM Mode Operation2PJ嘉泰姆
SOT23-6 Package2PJ嘉泰姆
三,应用范围 (Applications)2PJ嘉泰姆
2PJ嘉泰姆

 Li-ion Battery Charger2PJ嘉泰姆

 TYPICAL APPLICATIONS
USB Audio2PJ嘉泰姆
Wireless Mouse2PJ嘉泰姆
Digital Still Cameras2PJ嘉泰姆
MP3/MP4 Players2PJ嘉泰姆
Portable Instruments2PJ嘉泰姆
四.技术规格书下载（产品PDF）2PJ嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！2PJ嘉泰姆

 2PJ嘉泰姆

五,产品封装图 (Package)2PJ嘉泰姆
2PJ嘉泰姆
2PJ嘉泰姆

六.电路原理图2PJ嘉泰姆
2PJ嘉泰姆
2PJ嘉泰姆
七,功能概述2PJ嘉泰姆
2PJ嘉泰姆
1)General Description2PJ嘉泰姆
The CXSU63034 is a synchronous step-up DC-DC converter.2PJ嘉泰姆
It utilizes internal MOSFET switches to achieve high2PJ嘉泰姆
efficiency over full load current range. It operates at a2PJ嘉泰姆
fixed switching frequency of 1.2MHz, and uses the2PJ嘉泰姆
slope compensated peak current mode pulse width2PJ嘉泰姆
modulation (PWM) architecture. The device can2PJ嘉泰姆
operate with an input voltage below 1V and the2PJ嘉泰姆
minimum start-up voltage is 0.85V.2PJ嘉泰姆
2) Current Mode Operation 2PJ嘉泰姆
The CXSU63034 is based on a slope compensated peak2PJ嘉泰姆
current mode PWM control topology. It operates at a2PJ嘉泰姆
fixed frequency of 1.2MHz. At the beginning of each2PJ嘉泰姆
clock cycle, the main switch (NMOS) is turned on and2PJ嘉泰姆
the inductor current starts to ramp. After the maximum2PJ嘉泰姆
duty cycle or the sense current signal equals the error2PJ嘉泰姆
amplifier output, the main switch is turned off and the2PJ嘉泰姆
synchronous switch (PMOS) is turned on. This control2PJ嘉泰姆
topology features cycle-by-cycle current limiting which2PJ嘉泰姆
can prevent the main switch from overstress and the2PJ嘉泰姆
external inductor from saturating.2PJ嘉泰姆
3) Synchronous Rectification 2PJ嘉泰姆
The CXSU63034 integrates a synchronous rectifier to2PJ嘉泰姆
improve efficiency as well as to eliminate the need for2PJ嘉泰姆
an external Schottky diode. The synchronous rectifier is2PJ嘉泰姆
used to reduce the loss condition contributed by the2PJ嘉泰姆
forward voltage of an external Schottky diode. The2PJ嘉泰姆
synchronous rectifier is realized by a P-channel MOS2PJ嘉泰姆
(PMOS) with gate control circuitry that incorporates2PJ嘉泰姆
八,相关芯片选择指南           更多同类产品........    2PJ嘉泰姆

2PJ嘉泰姆

共有条评论 用户名: 密码: 验证码: 匿名发表